option drumdrive < enable | disable > This command is used to control the status of the 'drumdrive' option. If the drumdrive option is disabled then the firmware attempts to use the PLC interface to control the drum and assumes this is a THINK(tm) system. Gravure The device normally needs to be reset anytime an option is enabled or disabled for the change to take effect. This command is available. Expert 30-Aug-2001 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:25:07 2008 PST